This is a complete ITC kit that includes the P-SB7T Spirit Box, ANC-Mini Adjustable Noise Control Device and our most popular high end X1 Speaker. It is pre-tested and ready to use out of the box. The ANC-Mini was specifically designed to eliminate sweep noise, which allows the user to hear the Spirit responses more clearly. Be sure to watch our Spirit Response demonstration video below. This kit saves you about 23% compared to buying the individual devices separately.
Includes:
(1) P-SB7T Spirit Box
(1) ANC-Mini
(1) X1 Orbital Speaker
(3) Audio Cables
(1) USB Charge Cable for the Speaker
(3) AAA Alkaline Batteries (P-SB7T)
(2) AA Alkaline Batteries (ANC-Mini)
(1) Velcro Strip to attach the ANC-Mini to the back of your P-SB7 battery cover

Instructions:
1. Adjust P-SB7T (Rev 6.0 and 5.0) to volume level 20. P-SB7 (Rev 4.0) volume level 28-30
2. Connect the SPOUT from the P-SB7 to the ANC-Mini Audio Input
3. Turn the speaker ON using the slide switch located on the bottom. Wait for all speaker audio prompts to stop before proceeding to next step.
4. Connect the Audio output from the ANC-Mini to the Audio Input on the speaker.
5. For best performance Adjust your P-SB7T Sweep rate to 250ms and start sweeping. Note: You can adjust it to suit your individual preferences. But, I have found that the 250ms rate works best with our software algorithm.
6. Turn the ANC-Mini power switch ON
7. Adjust the Master Volume using the Orbital Speaker outer ring. CW increases & CCW decreases Volume. If you hear a beep, you've exceeded the speaker volume limit.
8. The RED Button Removes/Decreases Noise and the YELLOW Button Increases Noise.

Note:
1.The device has been tested and pre-adjusted by our technicians. If you wish to restore/reset the device press the RED & YELLOW buttons simultaneously and then proceed to press the RED button until the noise level suits your preference. You can also observe the RED LED on the top of the ANC-Mini. This LED will begin to blink as you near the optimum setting and it will stay ON when it is set correctly. You can then "Tweak" the RED/YELLOW buttons to get the perfect setting.
2. Be sure that the speaker is fully charged and that your batteries are fresh.